matte black cars The vinyl wrapping process can be significantly improved by removing moldings.

matte black cars

All hardware should be removed during an application. You can wrap certain sections without moldings and with less stress. matte black cars This will allow you to achieve a high-quality result while avoiding many potential problems. A molding can be removed in five minutes, matte black cars unlike other hardware such as rear lights or headlights. It will not delay your installation because you can still handle the vehicle wrap more easily. It is more difficult to do certain moldings around trunk and rear doors. You might damage the moldings if you don't pay attention. These are just a few examples you might find useful: 1. Citroen Jumper - License Plate Molding For vehicles such as Citroen Jumper, there is mold above the license plate. Swing the door and you'll see clips attached to the cover. matte black cars To remove the cover, www.vinylcarwrapshop.com use a plastic tool to pry it off and then loosen it using a tool such as a crowbar. After removing the cover, loosen the screws from the license plate molding. 2. Ford Taurus - Trunk Molding Ford Taurus vehicles have a plastic molding on the trunk. It's fine to leave it in. It is fine to leave it on. However, matte black cars removing it can speed up the wrapping process. You can open the trunk for this vehicle. You will also find plastic clips that hold the cover in place. You can remove the clips with a crowbar and open the cover. After it's done, you will be able to access the parts holding the plastic mold, which are bolts or plastic clips for Ford Taurus. matte black cars Be careful when taking them off. You will also find an electrical wire within. Before you remove the molding, make sure to disconnect it. Once you are done with the interior, matte black cars return to the trunk's surface. To remove the molding, use a plastic tool. You might damage it otherwise. You can do it every few inches using just enough pressure to remove it. 3. Volkswagen Transporter - License Plate Molding Volkswagen Transporter's situation is somewhat similar to Citroen Jumper. You will need to remove the license plate molding by opening the back door. There is a plastic cover with clips. matte black cars You can take them off and then remove the cover.

Car VinylWrap

The bolts holding the molding can be reached next. You can also loosen the wire and bolts. Once you are done, matte black cars you can easily remove the license plate molding from outside. Some moldings, like the ones above, may take a little longer to remove. It is worth it if you consider the risk that the removal lowers for you. There are many other types of difficult moldings. matte black cars These are just a few of the more common ones. For more wrap tips, visit teckwrap.com

matte black cars